Popular fittings › Three-way manifold
Three-way manifold
Feed three branches from one inlet. A free 3D printable manifold with every branch sized independently.
Open in the designer →
Opens with the sizes below. Change anything, then export 3MF, STL or STEP. Free, no account, runs in your browser.
Starting sizes
| End | Inner size | Connection |
|---|---|---|
| Inlet | 100 mm (3.94 in) | Smooth sleeve |
| Left | 50 mm (1.97 in) | Smooth sleeve |
| Center | 50 mm (1.97 in) | Smooth sleeve |
| Right | 50 mm (1.97 in) | Smooth sleeve |
Need another size? Every dimension is editable in the designer, in millimetres or inches.
What it is
One inlet feeding three branches, for running several tools or vents from one hose.
How to measure
For each end, measure the hose, pipe or port it joins with calipers. If that part slides into the fitting, measure its outside diameter and keep “Measure by: Inner diameter”. If the fitting slides into a hose, measure the hose’s inside diameter and switch to “Outer diameter”. Measure twice across the circle; flexible hose is rarely perfectly round.
Print tips
- The export already places every component in its recommended print orientation. Keep supports off sleeves, sockets and any sliding or tight-fit surface so they stay smooth; if your slicer asks for supports, paint them only where an outside overhang needs them.
- Use 3–4 perimeters for an airtight wall; infill matters much less than wall count for ducts.
Frequently asked questions
- What size should I measure?
- For each end, measure the hose, pipe or port it joins with calipers. If that part slides into the fitting, measure its outside diameter and keep “Measure by: Inner diameter”. If the fitting slides into a hose, measure the hose’s inside diameter and switch to “Outer diameter”. Measure twice across the circle; flexible hose is rarely perfectly round.
- What should I print it in?
- PLA or PETG both work for dust collection at room temperature. Print in PETG or ASA if the air is warm or the part sits in the sun. Use 3–4 perimeters for an airtight wall; infill matters much less than wall count for ducts.
- What hardware do I need to buy?
- Nothing is required at these starting sizes: it prints in one piece. A hose clamp is optional if a hose feels loose.
- Does it need supports?
- The export already places every component in its recommended print orientation. Keep supports off sleeves, sockets and any sliding or tight-fit surface so they stay smooth; if your slicer asks for supports, paint them only where an outside overhang needs them.
More popular fittings
4 inch Y splitterA 3D printable 4 inch dust collection Y fitting. Change each branch size and angle independently, then export 3MF, STL or STEP.
100 mm T junctionA 3D printable 100 mm T fitting with an independently sized side branch. Export 3MF, STL or native STEP.
Y splitter for duct and hoseA 3D printable Y splitter with one inlet and two independently sized branches. Set every size and angle, then export 3MF, STL or STEP.
T junction for duct and hoseA main duct with a perpendicular, independently sized side branch. Free 3D printable tee, export 3MF, STL or STEP.
Gated Y splitterDirect flow to either branch with separate printable sliding valves. Free 3D printable gated Y, any size.
Four-way crossFour ports, four sizes and independent angles. A free 3D printable duct cross, export 3MF, STL or STEP.