Popular fittings › Dual-port window panel
Dual-port window panel
Two independently sized exhaust outlets on one configurable window panel. Free 3D printable.
Open in the designer →
Opens with the sizes below. Change anything, then export 3MF, STL or STEP. Free, no account, runs in your browser.
Starting sizes
| End | Inner size | Connection |
|---|---|---|
| Outlet A | 100 mm (3.94 in) | Smooth sleeve |
| Outlet B | 75 mm (2.95 in) | Smooth sleeve |
Need another size? Every dimension is editable in the designer, in millimetres or inches.
What it is
A window insert with two hose outlets, for venting two machines through one window.
How to measure
Open the window to the gap you want and measure its width and height. Set the panel slightly smaller so it drops in. For each end, measure the hose, pipe or port it joins with calipers. If that part slides into the fitting, measure its outside diameter and keep “Measure by: Inner diameter”. If the fitting slides into a hose, measure the hose’s inside diameter and switch to “Outer diameter”. Measure twice across the circle; flexible hose is rarely perfectly round.
Print tips
- The export already places every component in its recommended print orientation. Keep supports off sleeves, sockets and any sliding or tight-fit surface so they stay smooth; if your slicer asks for supports, paint them only where an outside overhang needs them.
- Print in PETG or ASA if the air is warm or the part sits in the sun.
Frequently asked questions
- What size should I measure?
- Open the window to the gap you want and measure its width and height. Set the panel slightly smaller so it drops in. For each end, measure the hose, pipe or port it joins with calipers. If that part slides into the fitting, measure its outside diameter and keep “Measure by: Inner diameter”. If the fitting slides into a hose, measure the hose’s inside diameter and switch to “Outer diameter”. Measure twice across the circle; flexible hose is rarely perfectly round.
- What should I print it in?
- PLA or PETG both work for dust collection at room temperature. Print in PETG or ASA if the air is warm or the part sits in the sun. Use 3–4 perimeters for an airtight wall; infill matters much less than wall count for ducts.
- What hardware do I need to buy?
- Nothing is required at these starting sizes: it prints in one piece. A hose clamp is optional if a hose feels loose.
- Does it need supports?
- The export already places every component in its recommended print orientation. Keep supports off sleeves, sockets and any sliding or tight-fit surface so they stay smooth; if your slicer asks for supports, paint them only where an outside overhang needs them.
More popular fittings
3D printer enclosure exhaust, 100 mmVent a 3D printer enclosure into 100 mm hose: a rectangular bolt-on flange that transitions to a barbed hose end. Free and adjustable.
Window exhaust insertA 3D printable window insert with a 100 mm hose outlet, perimeter rim and mounting holes. Size the panel to your window.
Laser cutter exhaust adapterA 3D printable laser cutter exhaust adapter: 150 mm flanged duct to 100 mm hose barb. Resize it to your machine.
120 mm fan to 100 mm duct adapterBolt a 120 mm PC fan to 100 mm hose. 3D printable shroud with 105 mm hole spacing and a barbed hose end.
Window exhaust insertA window insert with perimeter rim, mounting holes and a hose outlet. Size the panel to your window and print it.
Printer enclosure ventA rectangular enclosure flange transitioning to a hose connection. Free 3D printable vent, any size.