Popular fittings › Blower jet nozzle

Blower jet nozzle

A round converging nozzle with an adjustable exit bore. Free 3D printable jet for blowers and fans.

Opens with the sizes below. Change anything, then export 3MF, STL or STEP. Free, no account, runs in your browser.

Starting sizes

Need another size? Every dimension is editable in the designer, in millimetres or inches.

What it is

Narrows the airflow into a fast, focused jet.

How to measure

Only the hose end has to fit exactly; size the tip to the job and the space you need to reach. For each end, measure the hose, pipe or port it joins with calipers. If that part slides into the fitting, measure its outside diameter and keep “Measure by: Inner diameter”. If the fitting slides into a hose, measure the hose’s inside diameter and switch to “Outer diameter”. Measure twice across the circle; flexible hose is rarely perfectly round.

Print tips

• The export already places every component in its recommended print orientation. Keep supports off sleeves, sockets and any sliding or tight-fit surface so they stay smooth; if your slicer asks for supports, paint them only where an outside overhang needs them.

Frequently asked questions

What size should I measure?

Only the hose end has to fit exactly; size the tip to the job and the space you need to reach. For each end, measure the hose, pipe or port it joins with calipers. If that part slides into the fitting, measure its outside diameter and keep “Measure by: Inner diameter”. If the fitting slides into a hose, measure the hose’s inside diameter and switch to “Outer diameter”. Measure twice across the circle; flexible hose is rarely perfectly round.

What should I print it in?

PLA or PETG both work for dust collection at room temperature. Print in PETG or ASA if the air is warm or the part sits in the sun. Use 3–4 perimeters for an airtight wall; infill matters much less than wall count for ducts.

What hardware do I need to buy?

Nothing is required at these starting sizes: it prints in one piece. A hose clamp is optional if a hose feels loose.

Does it need supports?

The export already places every component in its recommended print orientation. Keep supports off sleeves, sockets and any sliding or tight-fit surface so they stay smooth; if your slicer asks for supports, paint them only where an outside overhang needs them.

More popular fittings

• Crevice nozzleReach tight spaces with a long, narrow rectangular tip. Free 3D printable crevice tool for any vacuum hose.
• Wide fan nozzleSpread airflow across an adjustable wide slot. Free 3D printable nozzle for blowers and vacuums.
• Bellmouth pickupA flared capture hood with a smooth circular transition. Free 3D printable pickup for dust and fume extraction.
• Rectangular capture hoodA broad rectangular pickup tapering into a round extraction hose. Free 3D printable hood.
• Floor pickup nozzleA shallow, wide vacuum opening with an offset round hose connection. Free 3D printable floor nozzle.
• Oval air knifeA thin oval outlet for a broad blowing stream. Free 3D printable air knife for blowers.